With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
This Privacy Policy covers CanadianWoodworking.com's treatment of personally identifiable information that CanadianWoodworking.com collects when you are on the CanadianWoodworking.com site, and when you use CanadianWoodworking.com's services. This policy also covers CanadianWoodworking.com's treatment of any personally identifiable information that CanadianWoodworking.com's business partners share with CanadianWoodworking.com.

Wood crafts hardware such as hinges, catches, screws, screw eyes, and sawtooth hangers are just a few of the items we stock for your woordworking plans. With turn buttons, swivel hangers, hasps and shelf pegs, you are sure to find the hardware supplies that will fit your needs.  We also carry lamp supplies, wire, vinyl gloves, magnets, felt pads, and so much more. Check out our entire line of hardware and supplies!
The Lead Instructor for the course is Aled Lewis. You can see Fine Woodworking's video about Aled here. For each project, Aled is joined by a co-teacher who specializes in the relevant skills. The following list is subject to change. Most of the instructors have websites which you can visit for more extensive views of their work. See the list of instructors here.
First, use a drill to make a 1/8-inch-wide hole halfway down into a new cork ($3.99 for 30; winemakingsuperstore.com). Next, twist off the top of a vintage trophy (typically a few bucks each at thrift shops and garage sales). Apply superglue to the underside of the trophy top's base and the screw that extends from it. Insert the screw into the cork and twist the pieces together until flush and a tight bond forms. Allow one hour of drying time before using your prize design.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.
Toy-making was a special occupation of the the School's former kindergarten program in its earliest decades. The training offered young, mostly poor children not only brand new toys but also a set of usable skills. Today, with support from Thos. Moser, NBSS reflects on this legacy with a limited edition of 10 "Little Folks" Rockers lovingly handmade by School artisans. These charming collectors' items will benefit the Toys for Tots program, bringing joy and new toys to less fortunate children at Christmas.
Auditing:  MSF has an auditing policy that allows for students who have successfully completed a training level (Basic, Intermediate, Master-Level) to enroll again in the same level in order to deepen their mastery.  Auditing is available on a space available basis for 50% of the standard tuition.  Auditing students do not receive a second Certificate of Accomplishment.  Please note that auditing (for a reduced fee) is not available for individual Project & Skills Workshops that are not also part of the professional training (see Concurrent Classes).

This course is focused on developing the skills that will allow you to start to find your voice as a furniture designer / maker. Design will be the consistent thread through the numerous projects of this class. We will take a hybrid approach to furniture making by blending traditional hand tool techniques with pragmatic use of woodworking machines. 
As the oldest arts educational institution in the state, Maine College of Art has been helping students succeed since 1882. Located in the picturesque Arts District of Portland, Maine; the college-town enjoys a distinguished reputation for its beauty and artistic culture. Among its numerous awards, the location was named #1 Most Liveable City by Forbes Magazine. The intimacy of a mentorship-based education is ensured with the College’s student to teacher ratio of 10:1 (one of the best in the nation).
Hi there, I'm glad that you are here. Firstly, let me introduce you that my name is Kevin Smith and I'm a coffee addicted guy, a blogger. Secondly, the reason why I create this website is to analyze what's the best products on the market with high quality and affordable price so that I make a decision to buy the right products for my family, friends and me. Thirdly, I just want to learn more about Home & Improvement Tools and Appliances so that I could improve my sweet little home.
See the Light: Abundant windows and glass-paned doors allow sunlight to pour inside. The seamless transition between indoors and out makes the room appear larger. Open up a tight kitchen with floating shelves. While they won’t hide toasters and coffeemakers, they’re a sleek alternative to upper cabinetry, which often overwhelms a tiny space. | CoastalLiving.comSee the Light: Abund
The Austin School of Furniture & Design will soon offer comprehensive furniture immersive programs that range from an intensive week-long project build to full-time furniture maker programs. These comprehensive classes are intended for intermediate to advanced students and will require an application and interview process or ASFD instructor approval.

Description: Works of Ahhh Wood Painting Set is great for parties, school projects or fun at home with the family. The Nutcracker Prince kit includes: one wood nutcracker, fake fur hair and beard, five non-toxic acrylic paint tubs, one non-toxic glitter glaze, 12 gemstones, one sticker sheet, two paintbrushes and one instruction sheet with painting guide. Includes instructions for the new free painting app to plan your project.


Hi there, I'm glad that you are here. Firstly, let me introduce you that my name is Kevin Smith and I'm a coffee addicted guy, a blogger. Secondly, the reason why I create this website is to analyze what's the best products on the market with high quality and affordable price so that I make a decision to buy the right products for my family, friends and me. Thirdly, I just want to learn more about Home & Improvement Tools and Appliances so that I could improve my sweet little home.
Prerequisites:  Each level (Basic, Intermediate, and Master-Level) is a prerequisite for the next.  However, students entering our Professional Training series can submit to a Skills Assessment by one of MSF’s instructors to determine if they may enter into the program and receive more advanced instruction without first satisfying previous training requirements.

First, use a drill to make a 1/8-inch-wide hole halfway down into a new cork ($3.99 for 30; winemakingsuperstore.com). Next, twist off the top of a vintage trophy (typically a few bucks each at thrift shops and garage sales). Apply superglue to the underside of the trophy top's base and the screw that extends from it. Insert the screw into the cork and twist the pieces together until flush and a tight bond forms. Allow one hour of drying time before using your prize design.
In a nutshell, these are the 25 top small wood items that I like the most in my house or office. These projects are so easy that a professional woodworker can even build one while working on some other major wood project. Tell us if you enjoy the article. Have you tried any project from this list yet? Did you complete it? Please share your reviews, questions, and projects in the comments. I’d love to hear about your experiences with these small wood projects. Also, share this with more and more your woodworker friends.
From making your own picture frames to constructing your own furniture, woodwork is one area where many DIY’ers cut their teeth and where many skilled professionals make an honest living. Whether you’re wet behind the ears or a seasoned expert at the craft, here’s a roundup of handy new woodworking tools to consider for your next equipment purchase. PocketJig200 The […]

We have a small dining room area in our farmhouse that is separate from the living room and kitchen. The area is much smaller in space than our last house. I was little confused that our typical rectangular farmhouse table was not going to cut it. So, I walked in I came to know that we needed to build a round dining table. So, I searched for a plan design idea and build a very own round farmhouse dining table. I was an amazing DIY plan, I just love it!
Making a garden arched footbridge out of some wood boards can be fun, hard working plan and also it’s quite rewarding. We are providing the project tutorial for how to build an arched footbridge without rails or having rails. If you take your hands of work and have some basic woodworking skills you can easily build this type of bridge. While this garden bridge is too small to walk over but it can make a really stunning addition to your lush yard or garden. 

Milking and/or Faking an Accent for all it’s Worth.  Have you ever noticed that craftspeople with foreign accents are automatically assumed to be old-world artists worthy of obscenely large fees?  In this class, we will help you make the most of your foreign accent, or teach you how to fake one convincingly so that you can take advantage of these silly stereotypes and command 50-200% more for your work/commissions.
Build this handy stool in one hour and park it in your closet. You can also use it as a step to reach the high shelf. All you need is a 4 x 4-ft. sheet of 3/4-in. plywood, wood glue and a handful of 8d finish nails. Cut the plywood pieces according to the illustration. Spread wood glue on the joints, then nail them together with 8d finish nails. First nail through the sides into the back. Then nail through the top into the sides and back. Finally, mark the location of the two shelves and nail through the sides into the shelves. Don’t have floor space to spare? Build these super simple wall-mounted shoe organizers instead!
Craft projects that don’t require you to go out to the craft store and purchase a lot of supplies can be difficult to find, which puts a crimp in crafting plans when you don’t have a lot of money to spend. Although most of these projects do require you have materials on hand, most are things the average person has around the house (scraps from previous projects, old clothing, salt, soda bottles) or are things you can easily obtain for free (leaves, rocks, twigs, shells).
By posting on this site and forum, the poster grants to Canadian Woodworking Magazine/Website the unrestricted rights to use of the content of the post for any purpose, including, but not limited to, publishing the posted material, including images, in print or electronic form in a future issue or issues of Canadian Woodworking magazine or related Canadian Woodworking products, and to use the post for promotional purposes without further compensation, as well as the right to use the poster's name in a credit along with the post.

From making your own picture frames to constructing your own furniture, woodwork is one area where many DIY’ers cut their teeth and where many skilled professionals make an honest living. Whether you’re wet behind the ears or a seasoned expert at the craft, here’s a roundup of handy new woodworking tools to consider for your next equipment purchase. PocketJig200 The […]


Easy woodworking projects are a great way to test your DIY skill level. It's always such an accomplishment when you complete a DIY project you spent time and effort on. DIY woodworking projects can also be intimidating at first especially with all the hand tools you must use. Once you have all you need, however, from tools to a step-by-step guide, you can start making the designs more efficiently. If you're new to woodworking, continue reading below and find easy woodworking projects suited for any beginner.
There will be two instructors for this course. One of the school’s instructors will be there full time. The second instructor will change with each project so you are exposed to a wide range of aesthetics, techniques and approaches to furniture making. These will include local makers and designers including Jim Tolpin, Tom Dolese, Michael Hamilton, Seth Rolland, Jaap Romijn and Tim Lawson. Other makers from the Puget Sound area will share their experience with you. 

Some tools required to build a picture frame are a table saw, miter saw, measuring tape, wood glue etc. A table saw with a backing board and miter gauge can be used to get the right angle and lengths of picture frame every time. You can use builders square to arrange the final cut pieces before nailing, screwing or gluing. Check out the video tutorial below for more details.
Some tools required to build a picture frame are a table saw, miter saw, measuring tape, wood glue etc. A table saw with a backing board and miter gauge can be used to get the right angle and lengths of picture frame every time. You can use builders square to arrange the final cut pieces before nailing, screwing or gluing. Check out the video tutorial below for more details.

Making over plain cotton upholstery fabric requires nothing more than a household disinfectant and water. Working outside, and wearing protective eyewear and gloves, lay the desired yardage for your project flat on a sheet of plastic. In a measuring cup, mix together ½ cup bleach and ½ cup water. Use a plastic spoon to drib-ble the liquid all over the fabric. When you're satisfied with the pattern, let dry, then run the fabric through a regular cycle in your washer and dryer. Take it to a local upholsterer (we sent ours to tapemeasure
Your kitchen is the heart of your home, the epicenter for hosting and the hub for masterful meals. When you first moved into your home, everything was new and matched to create a uniform and beautiful kitchen space. As the years have gone by, though, you've made changes, swapped out appliances, and now there's something off about your kitchen. Chances are, it's probably the cabinets. Your once beautiful cabinets have become old and musty, creating a wall-to-wall eyesore in your favorite room of the house. Luckily, there are some easy ways to freshen up those cabinets and bring some life back to your kitchen.

Do you want to use an oil stain, a gel stain, a water-based stain or a lacquer stain? What about color? Our ebook tells you what you really need to know about the chemistry behind each wood stain, and what to expect when you brush, wipe or spray it on. It’s a lot simpler than you think! This is the comprehensive guide to all the varieties of stain you will find at the store and how to use them.
Toy-making was a special occupation of the the School's former kindergarten program in its earliest decades. The training offered young, mostly poor children not only brand new toys but also a set of usable skills. Today, with support from Thos. Moser, NBSS reflects on this legacy with a limited edition of 10 "Little Folks" Rockers lovingly handmade by School artisans. These charming collectors' items will benefit the Toys for Tots program, bringing joy and new toys to less fortunate children at Christmas.

Looking for a great gift for a friend or family member or maybe a Christmas gift? Recommended woodwork projects include a turned wood box with a lid or how to make a jewlery box. New to woodworking? Great! Check out these simple beginner’s woodworking projects. No matter the DIY woodworking project you can find your next gift idea in the wood craft videos listed below.
×